Reassembly And Operation Of Evaporative Condenser

iangsu Gwabin Heat Technology Co., Ltd. adapts to different media, different temperatures, different specific heats, different particle contents, different operating environments, etc. in terms of material diversity, structural variability, and multiple choices of forms.

The generator set should be reinstalled on the top of the house or on a leveled support frame. The exhaust system of the axial fan of the generator set must be higher than or at least equivalent to the top of the round capital turnover wall to prevent removal of the dehumidifier The machine steam flows back.

1. Piping: The layout of the piping should meet the requirements of the refrigeration cycle piping reinstallation standard, and the equalization pipe should be reinstalled between the cooler and the high-pressure accumulator to avoid other blockages and other blockages to return the steam parameters to the cooler .
2. When connecting the two cooling devices in series, the following standards shall be complied with: The liquid storage bend shall be set at the discharge pipe end of the cooling tower, and the discharge pipe shall have sufficient vertical riser, its height and width The pressure equalizing pipe between the accumulator and the cooling device with a ratio of not less than 1500Mm should be connected to the inlet of the cooling device. The effect of the liquid trap at the outlet pipe is to create a certain liquid seal to counteract the cooling device. The difference between the working pressure of the inlet and outlet of the pipe group.

 3. Water circulation system: due to the volatilization of the self-spraying water, the minerals and other residues in the water will be left in the water storage tank. The sewage should be discharged on time to avoid the accumulation of the above-mentioned chemical substances, otherwise the water will be acidic. The value or mineral composition will increase, causing corrosion and dirt.